3/26/2023 0 Comments Denon avr control protocolHave a look at the tutorials to install it on a NAS, computer, Raspberry Pi or get an eBox! Certified products are extensively tested in combination with Professional Designer and supported by OpenRemote certified Integrators.įirst, you will have to install OR controller. The functionalities of the following products are supported by OpenRemote. If your product is not listed here it most likely doesn't contain an RS-232 port for remote control. You can find below a list of all devices that OpenRemote should be able to control through this protocol. You will also need an RS-232 port on your OpenRemote controller or a suitable IP->Serial interface (although only limited support is currently available over IP) Receivers that contain both RS-232 and Ethernet port (AVR-380x and AVR-430x series) should be supported on RS-232 although exactly what features work is unknown at this time. We are not currently able to support this type of receiver (as none of us owns one!) although the protocol does look very similar to the one used by the RS-232 based devices. Many newer Denon receivers (AVR-1912 and others) contain an Ethernet port for remote control rather than the RS-232 port. The protocol has been extensively tested with the AVR-2807 but should work with all Denon receivers which contain an RS-232 port for remote control. The denonAVRSerial protocol allows OpenRemote to control the Denon AVR range of AV processors/receivers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |